By

Update (November 19, 2017) We have switched providers and are now back up and running on our audio streaming.  Please keep in mind that we have little or no control over third parties, such as Tune-In or ShoutCast, that rebroadcast our signal.  It may take a considerable amount... Read More

This last Friday and Saturday, work was completed to inspect, check structural bolts, then wash and paint the tower located at KOLU’s studio. Chief Engineer Martin Gibbs and contractor RS Technology, along with a “ground crew” were able to finish this important work during one of... Read More

Monday night, August 8, smoke was observed over an equipment shelter near KOLU’s studio at Riverview Baptist Church.  This shelter is a “nerve center” of sorts for KOLU, relaying the broadcast signal to our main transmitter on Beck Mountain as well as handling all network traffic... Read More

Update – The air conditioner was repaired Wednesday, June 8 and we were able to turn the main transmitter back on at 5pm.  KOLU is once again transmitting at full power.  Thank you for your patience and prayers! Original post -Our main transmitter at KOLU had to go off line... Read More

At 10:20 Saturday, June 6, Dr. John Paisley, Station Manager for Christian Family Radio, turned on the massive disconnect switch that powered up KOLU’s new transmitter.  Then, Chief Engineer Martin Gibbs had Pastor Paisley start the transmitter to warm up the tubes before... Read More

KOLU’s new transmitter has passed it’s final test, which means we will be applying for our license to operate at 39,000 watts as soon as we receive the test report. Testing of “Radio Frequency Radiation”, or “RFR”, was required by the... Read More

On Thursday, May 7, we successfully tested KOLU at 39,000 watts! The test started around 3pm and the transmitter ran flawlessly until we returned to our current 4,100 watts at around 7pm. A couple of quick drives around town and to nearby areas confirmed the increase in signal... Read More

We have crossed another milestone in the upgrade of KOLU to 39,000 watts.  The 20,000 watt transmitter has been tested at full power and is working well! Along the way, we have installed a wire tray that will carry wiring that sends signals to control and monitor th... Read More

As we continue to work on upgrading KOLU’s power to 39,000 watts, we now have electrical power connected.  We have also re-connected the wiring inside the transmitter in preparation for initial testing. Several listeners have wondered why it is taking so long to complete... Read More

In late March, Christian Family Radio Staff visited our new Yakima translator site to replace a temporary support on the receive antenna and to set up Internet access for the equipment installed there.  Although it took a bit longer than we planned (these kinds of things seem to... Read More